Detailed tutorial for monitoring system installation

0 Comments

With the development of video surveillance technology for civilian use, more and more supermarket restaurants, office factories, and even homes have installed surveillance cameras, so how to install surveillance cameras, how do we install surveillance cameras? The monitor installation tutorial steps are explained as follows

1 First, determine the area to be monitored to determine the installation position of the surveillance camera and monitor the camera lens size for optimal monitoring. The installation position of the surveillance camera is recommended to be more than 3 meters, but not too high. The installation position is too low to be damaged by humans. The installation position is too high and it is not convenient for maintenance.

2 After selecting the appropriate position, use the surveillance camera bracket to mark the position where you need to punch the hole at the installation position. Then use a hammer drill to drill on the wall. If it is a wooden structure, the bracket can be fixed directly with self-tapping.

3 Insert the plug in the well-behaved eye and fix the surveillance camera bracket to the wall with self-tapping. Be careful to fix it firmly, otherwise the picture will shake after installing the surveillance camera.

4 After the surveillance camera bracket is fixed, fix the surveillance camera on the bracket universal joint and adjust the angle of the surveillance camera according to the area to be monitored. After the surveillance camera is installed, wiring begins. The surveillance camera has a power line and a signal line. The power line is powered by a 12V 2A power supply, and the signal line is different depending on the type of surveillance camera. The analog surveillance camera is transmitted by coaxial cable, and the network surveillance camera is transmitted by network cable.

5 After the line connection is completed, connect the line of the hard disk recorder to the back end, check whether the bracket screw camera screw is fixed; the outdoor unit should check that the surveillance camera must be waterproof; whether there are fingerprints and other dirt in front of the lens. After that, the power can be debugged. If there is no fault in the surveillance camera power supply, the monitoring and monitoring camera screen can appear on the back-end display by debugging the monitoring software of different manufacturers.

Leave a Reply

Your email address will not be published. Required fields are marked *